Sheet metal penetration problems
-
- Posts: 41
- Joined: Fri Apr 29, 2016 2:41 pm
Sheet metal penetration problems
As you can see in this video I am experiencing problems with sheet metal simulation. I am using a btGImpactShape. Any suggestions or fixes?
Last edited by erbisme4@yahoo.com on Wed Jan 18, 2017 9:53 pm, edited 1 time in total.
-
- Posts: 96
- Joined: Wed Mar 16, 2016 10:11 am
Re: Sheet metal penetration problems
I think Bullet doesn't support 0-thickness shape very well, except infinite plane.
Almost all shapes should have thickness and it is the best to be watertight (enclose a certain volume).
I guess your shape should be extruded a bit.
I don't know any other ways, and I am just a beginner.
Almost all shapes should have thickness and it is the best to be watertight (enclose a certain volume).
I guess your shape should be extruded a bit.
I don't know any other ways, and I am just a beginner.
-
- Posts: 350
- Joined: Sat Jul 04, 2015 10:33 am
- Location: Bern, Switzerland
Re: Sheet metal penetration problems
I would suggest the same, in case you experience tunnelling through your objects, then give the object some volume to collide against before you think of anything else.