Sheet metal penetration problems

Post Reply
erbisme4@yahoo.com
Posts: 41
Joined: Fri Apr 29, 2016 2:41 pm

Sheet metal penetration problems

Post by erbisme4@yahoo.com »

As you can see in this video I am experiencing problems with sheet metal simulation. I am using a btGImpactShape. Any suggestions or fixes?
Last edited by erbisme4@yahoo.com on Wed Jan 18, 2017 9:53 pm, edited 1 time in total.
hyyou
Posts: 96
Joined: Wed Mar 16, 2016 10:11 am

Re: Sheet metal penetration problems

Post by hyyou »

I think Bullet doesn't support 0-thickness shape very well, except infinite plane.
Almost all shapes should have thickness and it is the best to be watertight (enclose a certain volume).
I guess your shape should be extruded a bit.
I don't know any other ways, and I am just a beginner.
benelot
Posts: 350
Joined: Sat Jul 04, 2015 10:33 am
Location: Bern, Switzerland
Contact:

Re: Sheet metal penetration problems

Post by benelot »

I would suggest the same, in case you experience tunnelling through your objects, then give the object some volume to collide against before you think of anything else.
Post Reply